The red light will blink once and remain on. NOTE: If there is not a device button on the remote for your type of device, you can use any device button on the remote.
Use the number buttons on the remote to enter the first code shown above. The red light will turn off after entering the fourth digit. Point the remote at the device. Test the buttons on the remote to see if the device responds as you would expect.
If the buttons do not operate the device, return to Step 1 above and use the next code in the list. Denon Soundbar. Samsung Soundbar. Chunghop RME. GE Universal Remote. Zenith Universal Remote Control. RCA 3 in 1. Go to step 3. Push the button. Wait 15 seconds. Go to step 4. Unplug your receiver from the wall outlet.
Wait 15 seconds, then plug it back in. Try your remote. Even the glass door on your entertainment center can cause interference. Keep your receiver and remote out of direct sunlight. Also, try turning down the brightness on your TV.
First, which remote do you have? Find them by using this code lookup tool. Follow the on-screen prompts to complete the process. Slide the mode switch located at the top of the remote to TV. Hold down the Mute and Select buttons at the same time. Let go when the green light flashes twice. Enter The green light should flash twice again. While you continue to aim the remote at your device, hold down the Mute and Enter buttons.
Press Menu on the remote. Follow the on-screen instructions to complete the pairing process. Use the instructions below for manual pairing. While aiming the remote at your device, hold down the Mute and Select buttons.
0コメント